Installation and debugging of channel steel punching machine is essential in the work. Only in this way can the probability of equipment failure be reduced. Do you know the installation and debugging of channel steel punching machine have three major precautions? Before the installation of channel steel components, the first-class channel steel punching machine manufacturers emphasize that all components should be cleaned sufficiently, and the installation can be carried out after no pollution, and the sealing test shall be conducted if necessary. And in order to reduce the use of problems as far as possible, channel steel punching machine manufacturers remind that in the case of necessity, should also do sealing test. Pay attention to keep the software and system clean during installation < br style = "list style type: none;" / > the popular channel steel punching machine manufacturers introduce that special attention should be paid to cleanliness during the installation of channel steel components, so as to prevent foreign matters from entering the hydraulic system and causing channel steel system failure. At the same time, the channel steel punching machine reminds us that the channel steel oil can only be added to the oil tank after filtration, and the old and new oil can not be mixed because the old oil contains a large number of solid particles, moisture, gum and other impurities. The channel steel punching machine manufacturer reminds the hydraulic system pipeline to be fixed in place after the pipeline connection, and no dead bending is allowed in the pipeline. During the commissioning process, it is necessary to observe whether the pump, cylinder, valve and other components in the system work normally, whether there is leakage, and whether the oil pressure, oil temperature and oil level are within the allowable range. At the same time, the channel steel punching machine manufacturer stressed that the inlet and outlet pipelines of oil pump should not be connected wrong, and the seals of pump, cylinder, valve and other components should be installed correctly. < br style = "list style type: none;" / > the above three points for attention in the installation and commissioning of the punching machine introduced by the channel steel punching machine manufacturer. In addition, it should be noted that the arrow direction or mark on various valve bodies should be observed during installation, and the air flow direction should be complied with. At the same time, the hydraulic punching machine manufacturer also reminds the dynamic sealing ring not to be too tight, especially the U-shaped sealing ring, otherwise the resistance is too large.