&China is the world's hardware production and export, accounting for 85% of the global hardware industry, while stainless steel hardware accounts for about 60% of the total output. Stainless steel stamping machine is more and more used in many hardware processing industries. The stainless steel pipe of the automatic punching machine can completely solve the difficult problem. The problem of low speed completely replaces the existing bench drilling machine and manual punching machine, and indirectly solves the environmental pollution problem caused by using the table type drilling machine. At the same time, the production cost is saved and the environment is protected. Stainless steel punching machine is more and more widely used in China, and its development speed is faster and faster. However, attention should be paid to maintenance when using in order to improve the service life. Take a look at the routine maintenance of the stainless steel press. < br style = "list style type: none;" / > & nbsp; & nbsp; first, use it after power failure, then clean the workbench and mold between the wastes and lubricate it with grease. < br style = "list style type: none;" / > & nbsp; clean the iron filings on the rack and guide rod, and clean and maintain the oil. Change the driven gear oil in the gearbox. Generally, the continuous operation is half a month, which needs to be replaced. The new machine should be replaced every three months. The gear lubricating oil should be GB 460. The punch is often replaced and replaced because it is not easy to change the die loss of the punch, which is not conducive to the cooling of the burr or the hole is not ideal, thus shortening the service life of the punch. The use of the stainless steel punching machine is very simple. We can't do anything wrong at all. Pay more attention.