With the development of industrial technology, a variety of mechanical products emerge one after another. Next, let's talk about the punching machine for strip steel. What are the safety technical regulations for the punching machine? Before starting, check whether the transmission parts, connecting screws and pin shafts of the punching and shearing machine are loose. Whether the electrical equipment is well grounded. Before operation, all parts should be lubricated, and the test run should be carried out for two to three minutes before operation. < br style = "list style type: none;" / > & nbsp; & nbsp; 3. Overload is not allowed and punching and shearing of quenched steel is strictly prohibited. Wear gloves and labor protection articles while working, and do not wear sandals and slippers. When punching and shearing, always add oil to the punch to prevent the upper and lower punch from skewing. When feeding, pay attention to finger safety, especially when the sheet material is washed to the back and the presser foot can not press the sheet metal, punching and shearing are forbidden. It is strictly forbidden to disassemble and proofread the cutting edge and die. Do not strike the die, cutting edge and other parts with force. < br style = "list style type: none;" / > & nbsp; & nbsp; 8. Strictly control the specification range of sheet metal and strictly prohibit punching and shearing when exceeding the specification range. No other articles and large amount of materials should be piled up in the workplace, and should be adjusted and cleaned in time. < br style = "list style type: none;" / > & nbsp; & nbsp; 10. Shut down and power off in time and clean up the site after work. < br style = "list style type: none;" / > & nbsp; & nbsp; the punching machine for strip steel is a further development of the punching machine for strip steel. It solves the problem that the punch needs an independent feeding system, so its volume is small.